Straight Abutment compatible with Friadent Frialit® / XiVE® Internal Hex 3.4mm Platform — Engaging, Titanium Screw Included (F-3.4SLIAF-02-2.0)

What it is. A straight abutment is the piece that screws into the implant and gives the crown something to sit on. Straight means its axis follows the implant’s axis — it does not correct for angle. It is the simplest and most common abutment in implant dentistry. Use it when the implant was placed in a good position and the crown can sit directly above it.

How to use it

1. Remove the healing abutment.
2. Seat the straight abutment and torque to the system’s specification.
3. Confirm full seating, radiographically if there is any doubt.
4. Take the impression or scan, or fit the crown if it is already made.
5. Cement or screw the crown into place.

Watch the instruction videos for this system →

• Engaging — it indexes to the implant’s hex so the restoration cannot rotate. Use it for single crowns.
• If the implant is tilted and the crown would not sit over it, you need an angled or prepable abutment instead.

Material: Grade 23 ELI titanium (Ti-6Al-4V ELI, ASTM F136) · Driver: 0.050" (1.27mm) hex · Machined at our facility in Bergenfield, New Jersey · Compatible with Friadent / XiVE Internal Hex 3.4mm.

System names are trademarks of their owners. Titan Implants, Inc. is not affiliated with, sponsored by, or endorsed by them; names identify compatibility only.

Also useful: the Titan Implant Locator Pin threads into the implant so the abutment slides over it and seats before you place the screw. It also lets you check implant parallelism. It is a seating tool, not an impression device, and it does not work with solid abutments, which have no through hole.