All-plastic burnout pattern compatible with the conical abutment used on the ZimVie / Biomet 3i external hex system at the 6.0mm seating surface. Produced to the referenced system's original prosthetic specifications.

This seats on the abutment, not on the implant. The conical abutment is already screwed into the implant; this coping goes over it and the technician waxes and casts the superstructure on top. It will not seat on a bare implant platform. Where the restoration is being built directly on the implant, the part needed is an implant-level castable abutment — see the 6.0mm UCLA plastic sleeve (T-6PS) or the 6.0mm castable straight locking abutment (T-6PSLIAF-01-4.0). [shared, cross-references vary]

Hexed and non-hexed. Hexed indexes to the abutment's anti-rotational feature and is used for single units. Non-hexed is rotational, which is what allows two or more copings to seat on a common path of insertion — the normal choice for splinted bridges and bars over conical abutments, since achieving passive seating across several abutments requires rotational freedom at each.  

Dimensions refer to the abutment, not the implant. The 6.0mm figure identifies the seating surface of the implant the conical abutment was placed on. Confirm the conical abutment reference itself before ordering — the same implant platform can carry conical abutments of different collar heights and coronal diameters, and the coping matches the abutment. 

The retaining screw seats into the abutment. It is not an implant-level screw and the two are not interchangeable. An implant abutment screw will not retain this coping.  

Casting. Supplied as a sacrificial pattern formulated to burn out under a standard investment casting cycle. Follow your investment manufacturer's recommended burnout schedule — complete elimination of the pattern depends on reaching and holding the specified temperature. The finished restoration is the cast metal; this component does not remain in service.  

Verify on the analog before wax-up. Seat the coping on the conical abutment or its analog and confirm full seating before adding wax. A molded plastic connection carries greater tolerance than a machined metal one, and on a multi-unit case the fit should be verified at every unit rather than assumed from one.  

Grade 23 ELI titanium (Ti-6Al-4V, ASTM F136) retaining screw included.  

Also for the 3i external hex conical abutment. A castable coping is available for the 4.1/5.0mm seating surfaces (LC-4CPS-T).

Manufactured in Bergenfield, New Jersey. SKU T-6CPS.