Closed-Tray Impression Pin compatible with Calcitek Threadloc External Hex 3.75mm Non-Hexed One Piece (Closed Tray, Used only for multi-unit restorations or denture) (TN-4OPIP-C)

What it is. An impression coping is a small part that screws onto the implant or abutment only while you take the impression. It records exactly where the implant sits and which way it points, so the laboratory can reproduce that position on the model. The laboratory cannot see into the patient’s mouth.

How to use it

1. Remove the healing abutment.
2. Screw the impression coping onto the implant or abutment and confirm it is fully seated — radiograph it if there is any doubt.
3. Take the impression. Open tray: unscrew through the tray before removing. Closed tray: the coping stays in the mouth and is picked up afterwards.
4. Attach the matching analog and send it to the laboratory.
5. Replace the healing abutment in the patient.

Watch the instruction videos for this system →

• This part works at abutment level — it seats on top of a multi-unit abutment, not directly on the implant.
• An incompletely seated coping is the most common cause of a restoration that will not fit. Verify before you take the impression.

Machined at our facility in Bergenfield, New Jersey · Compatible with Calcitek External Hex 3.75mm.

System names are trademarks of their owners. Titan Implants, Inc. is not affiliated with, sponsored by, or endorsed by them; names identify compatibility only.