Ball Abutment compatible with American Dental Implant Corporation Internal Hex 5.7mm Platform — with Metal Housing & 2 O-Rings (P-57BHA-ADI)

Ball abutment (O-ring / ball attachment) for implant-retained overdentures on ADI 5.7mm. Supplied with metal housing and two O-rings. See all overdenture ball abutments and replacement O-rings.

Ball head abutment is a one piece abutment with a ball projection on top that is used with two or more implants to fixate dentures to implants in a fully edentulous arch. It comes with a metal housing and retentive rubber o-rings. Ball head abutments can be processed into the denture using pick-up chairside technique or laboratory technique.

• Ball head abutment comes as a kit which includes Metal Housing & Two Rubber O-Rings
• Requires additional purchase of BALL HEAD WRENCH for first time orders.
• Ball Head Wrench must be purchased separately.
• Recommend the use of two ball head abutments per patient. The use of more than two ball head abutments may have problems with parallelism

Technical Considerations:

• A minimum inter-occlusal clearance of 6mm and cuff height is required.
• Implants must be relatively parallel to one another with less than 10 degree total divergence.

Implant system and component names mentioned on this page are trademarks of their respective owners. Titan Implants, Inc. is not affiliated with, sponsored by, or endorsed by those companies; their names are used only to identify compatibility.