UCLA Castable Abutment (All-Plastic Burnout Sleeve) compatible with ZimVie Biomet 3i External Hex 6.0mm Seating Surface Hexed and Non-Hexed, All-Plastic UCLA Sleeve — Engaging or Non-Engaging, Titanium Screw Included (T-6PS)

• Compatibility: Biomet 3i Ext Hex, 6.0mm platform
• Component: UCLA Castable Abutment
• Material: All-plastic burnout pattern
• Includes: Titanium screw included
• Manufactured by: Titan Implants, Inc. — Bergenfield, New Jersey, USA

UCLA castable abutment (all-plastic burnout sleeve) for Biomet 3i External Hex 6.0mm. Wax up and cast a custom abutment or a screw-retained crown. Choose engaging (hexed) for single crowns or non-engaging for bridges and splinted units. Not sure which part fits? See the 3i External Hex abutment selection guide.

UCLA Castable Abutment are wax-compatible, burnout-ready abutment blanks that allow laboratory technicians to design and cast fully custom abutments — including emergence profile, margin placement, and angulation correction — without being constrained by off-the-shelf dimensions.

Compatible with ZimVie / Biomet 3i implant systems (External Hex) with a 6.0mm platform. Available in hex and non-hex configurations. The Castable Abutment burns out completely in a standard casting cycle, leaving a clean custom abutment.

Made in Bergenfield, NJ by Titan Implants.  

Not sure which to order? Engaging vs. non-engaging: how to choose.

Shipping: ships same day when ordered by 4 PM ET, from our Bergenfield, New Jersey facility.

Implant system and component names mentioned on this page are trademarks of their respective owners. Titan Implants, Inc. is not affiliated with, sponsored by, or endorsed by those companies; their names are used only to identify compatibility.